Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 running 8.5(5) CATOS and am wondering how to enable rsh so that I can issue CATOS commands. I have found information for the IOS but got "connection refused" response. The IOS commands I used were username root privilege 15ip rcmd rsh...
Please advise, and thanks in advance.I have a new WS-C3750G-12S running 12.2(25)SEB2 and since I have working SFPs around so I thought I could just order this switch without any SFPs. I installed my good SFPs and when the 3750 boots up, I get the f...
Hi there, I have already successfully setup a plain LAN-to-LAN connection without any problem on a couple of 3005 connected via a 2611XM. Now, I have modified the 2611 to do NAT on the LAN-to-LAN originator side. I have modified both 3005 to supp...
Hi gurus, A customer is interested in setting up a LAN-to-LAN connection using a 3005 on each side connecting via SDSL. As far as I know, there are no other routers between the non-Cisco SDSL modems before the internet. How should I address the p...
Hello Cisco gurus, I look forward to learning from you guys and gals. Can someone please help me with the following:- basic differences between an ip route table and ip forwarding table- how are the entries in the two tables be different?- what's ...
Hi prkrishn, Thanks for your update. I have a couple of follow-up questions now that I have acquired some Cisco approved 3rd party SFP and I am not see these errors upon SFP insertion. I took 1 SFP from the lot and verified that it works on someo...
Port rate limit can be set from 1-100% of port speed. The documentation mentions that port rate limiting can only be configured on Cisco MDS 9100 Series switches, Cisco MDS 9216i switches, and MPS-14/2 modules. The command is "switchport ingress-ra...
