Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Under policy-map and class i cannot get the set command listed. I want to use the "set" command to set the dscp field. Is there anything besides cef that has to be enabled ? Router(config)#policy-map BetaRouter(config-pmap)#class ARouter(config-pmap-...
I want to know if it is possible to disable OSPF downward bit propagation. The PE router will set the downward bit when flooding LSA's from other sites to the hub router and as they pass through the spoke router and back to the PE-router the PE rout...
This is my problem :I have one management site and 3 other sites, site A,B and C. The management site is represented by one VRF and is located on the router(made up of 3 loopback addresses, no physical interfaces, the site is located on one of the ro...
I have the following problem: I cannot ping either of the CE router int. from the PE routers but i can ping the PE router interfaces from CE router. Interface status(PE to CE) on each of the PE routers is UP/UP.The problem seem to caused by this inte...
OK, that made it clear to me. I can use the rate-limit (CAR) statement used with access lists on an interface to set value for the dscp field in the ip header. This will give the same functionality as CB marking. Thanks.
I figured out the problem. There was a problem with the label forwarding table at the first PE router. I owe my thanks to Rajiv Asati, excellent MPLS VPN troubleshooting guide. I used OSPF as the IGP protocol and there was no problem with iBGP VRF e...
Thanks for your replies. I tried to use per-packet loadsharing, it did not make a difference. I am using Pcattcp to measure throughput from PC 2 to PC 1. With both interfaces on LabD up i get about 116KBytes/s, with interface serial 1 shutdown i get ...
