Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I find the Command Reference Guide for Cisco Prime Infrastructure 3.7 confusing on the topic of how can I create another admin account. With the username command, the only options are Network-Admin, Security-Admin or operator. But the the command ref...
I have CCM 4.0 installed and Cisco IP communicator. After starting the communicator, Cisco IP communicator displays error message: "Registration Rejected: error mismatch".
Hello,Two of my 3750 switches in a stack are logging a lot of stack linke changes. Is this due to a faulty cable/port? If I change the cable and it persists, what would be the next step?Thank youChris
Logged these two error messages:Controller port error, Interface Fa1/0/17 Power controller reports power Imax error detected.Controller port error, Interface Fa1/0/17 Power controller reports power Tstart error detected.I could not find any info on t...
I am working through bringing up back to back T1 PRIs for voice calls. I have the basic configurations on configuring the T1s, but when I try to forward calls and / or data (depending on the configuration) it fails. I know how to configure regular T1...
I wanted to change the admin password setup during the install. I found that in version 3.7 Cisco introduced a new Cli command “change-password”. Using this command, a user can change their own passwords. This command is available for all roles.note:...
Per Cisco:make sure there is no external pressure on the cables. Cabinet enclosure might be compressing the cable.Make sure the cables are properly seated and secured.Make sure you have the right length cables.Check for proper grounding of rack/cabin...
This is a voice lab I am setting up so I'm using a back to back cable to simulate my T1 connection. I have since got it running, (it was a cabling problem) but now I'm trying to send voice accross, unsuccessfully.
