Dear Sir,
If I have the below scenario:
1- Two routers facing the internet each of them is connected to different ISP.
2- both routers should provide HA in configuration.
3- Internet Firewalls will be configured in (Active/Standby).
4- hav...
Dear,
on Cisco C8200L-1N-4T router what is the difference between :
1- (NIM-ES2-4)
vs
2- (C-NIM-2T) that is "Cisco Catalyst NIM Module 2-port 1GE SFP with MACSec Cisco Catalyst NIM Module 2-port 1G Ethernet/SFP with MACSec"
BR
...
Dear Gents,
What are the recommendations that should be followed if we have a local site with wireless APs operating in Local Mode and registering on a local Primary WLC on the same network. and in the case of Primary WLC failure, the APs w...
in the H+1 high availability configuration for C9800 WLC. if we have one local WLC act as an Primary WLC and the (+1) WLC is placed over the internet and it act as the secondary WLC. what is the best practices for the (internet or WAN) circuit addres...
If I have a local site with LAN Network that has CUCM Publisher, CUCM subscriber and some IP phones. This LAN network is connected to the internet through firewall and router. And there is a remote site over the internet which has another CUCM Subscr...
So, Can I say as per above the below:
1- (NIM-ES2-4) : (4-port Layer 2 Gigabit Ethernet LAN Switch NIM) So, these ports works only on Layer 2 and I can't assign IP addressed to them. So, what are the use cases for these line cards on a router.
vs...
your support is highly appreciated.
So, as a conclusion since the AP works only in one mode. lets say for our scenario we configure the AP to work in FlexConnect mode and its Primary WLC located at the local network with a private IP and the Seconda...
Again Many thanks for your ultimate support.
Can I configure the AP to register in (local mode) for the Local Primary WLC, and in case the Local Primary WLC fails then the AP will register in (FlexConnect mode) for the Remote Secondary WLC located ov...
Thanks for the prompt reply.
So, if the (20 ms) is not guaranteed on the internet link and if we considered to operate the Wireless AP in FlexConnect mode (as a better option for above senario) can you support me on the below:
1- will the AP in Fle...