Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to make use of a POTS line connected to FXO port on 2851 for 911 calls going out of the router. I understand that dial-type, signaling type is important and I have checked that to be dtmf and loopstart respectively. Here is my configurati...
I am using a HWIC-4ESW (4 port FastEthernet card) on a Cisco 3845 to do decnet with a switch connected to it. I am running an enterprise version of the IOS which supports decnet, but I can't assign 'decnet cost #' to the interface. I see decnet comma...
I have a site with two routers (voice gateways) with an ISDN PRI connected to each of them. I had one of the PRIs working for 2 months (connected to one gateway) and recently we have added the second PRI (on the second gateway). IP vice, the gateways...
Hi Mahesh,On a WAN interface a simple ping goes out to the other end and comes back and gives out the result. Basically performs a small loop test for connectivity check and gives you the result. I don't know how your network is setup but I thought I...
We were not able to connect a regular phone (with loopstart) and make a call out, thats when Telco told us that it is ground start. Any other suggestion?Thank you in advance.
Thanks for responding to my issue. I have setup a preference for my dialpeer. The problem is layer 1 I think. I have put a plar on the pots dial-peer. It is interesting that incoming call works just fine. It rings on my IP phone, but the outgoing cal...
