About ranjanibharadwaj

ranjanibharadwaj · 11-21-2007

Is there a difference between vtp pruning and controlling the vlans allowed using the switchport trunk allowed vlan vlan-list?Thank you.

ranjanibharadwaj · 07-26-2007

Hi,I have been the following message continuosly on my 2851. Jul 26 11:02:52.209 EDT: %SKINNYSERVER-3-NOINIT: Can't initialize Skinny serverJul 26 11:02:52.209 EDT: %SKINNYSERVER-3-NOINIT: Can't initialize Skinny serverJul 26 11:03:02.209 EDT: %SKINN...

ranjanibharadwaj · 07-24-2007

I am trying to make use of a POTS line connected to FXO port on 2851 for 911 calls going out of the router. I understand that dial-type, signaling type is important and I have checked that to be dtmf and loopstart respectively. Here is my configurati...

ranjanibharadwaj · 03-02-2007

I am using a HWIC-4ESW (4 port FastEthernet card) on a Cisco 3845 to do decnet with a switch connected to it. I am running an enterprise version of the IOS which supports decnet, but I can't assign 'decnet cost #' to the interface. I see decnet comma...

ranjanibharadwaj · 02-27-2007

I have a site with two routers (voice gateways) with an ISDN PRI connected to each of them. I had one of the PRIs working for 2 months (connected to one gateway) and recently we have added the second PRI (on the second gateway). IP vice, the gateways...

ranjanibharadwaj · 11-22-2007

Thanks everybody for your responses. It helped.

ranjanibharadwaj · 11-21-2007

Hi Mahesh,On a WAN interface a simple ping goes out to the other end and comes back and gives out the result. Basically performs a small loop test for connectivity check and gives you the result. I don't know how your network is setup but I thought I...

ranjanibharadwaj · 08-13-2007

Yes

ranjanibharadwaj · 08-13-2007

We were not able to connect a regular phone (with loopstart) and make a call out, thats when Telco told us that it is ground start. Any other suggestion?Thank you in advance.

ranjanibharadwaj · 08-07-2007

Thanks for responding to my issue. I have setup a preference for my dialpeer. The problem is layer 1 I think. I have put a plar on the pots dial-peer. It is interesting that incoming call works just fine. It rings on my IP phone, but the outgoing cal...

Member Since	‎10-25-2004 04:24 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	36
Total Helpful Votes Received	3

User Statistics

User Activity

Difference between vty pruning and allowed vlans command

Skinny Server logging messages

Using FXO POTS line for 911 calls

Can't assign Decnet Cost on fast ethernet

Route Group and Route List related question

Re: Difference between vty pruning and allowed vlans command

Re: ping problem

Re: Using FXO POTS line for 911 calls

Re: Using FXO POTS line for 911 calls

Re: Using FXO POTS line for 911 calls