Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way that I can properly troubleshoot if I have a LEC issue or dropped packets from a 2421 or ATA?I have issues terminating many faxes from 2421's. I almost never get ATA to send fax properly. This is,I think that config is right as sometim...
Currently we have a calling plan that has the XXXXXXX for local calling and [2-9]XXXXXXXXX for metro and 1[2-9]XXXXXXXXX for LD. Call are completing, but LD carrier says there are getting one number BTN (billing telephone #) for all DID's we are send...
Need help with my call routing on CCM4.1;Have a scenario where I receive 7 digits from telco on PRI. All have been well for sometime. We have been able to port any number without issue. We recently starting implementing 9.XXXXXXX dialing for one part...
I have 4.1 installed on an HP DL3202.66 with 2GB RAM, (2)80Gigs HDD's.When I try to install the upgrade DVD, it says that this processor is 'Not Supported'How can ths be?When I look at the upgrade support sheet, it says something about support for th...
I know that there is that plugin that Cisco provides, but I am seeking the same thing. To know about call thresholds, etc.Let me know if you found anything.
Try setting one of the phones on Asterisk side to 711. See if you can transfer to that phone. Also, as you know SCCP is Cisco only protocol. I doubt Asterisk supports any SCCP functionality.Thirdly, do you have a DSPfarm or Codec transformation in pl...
Strange as it looks to be right config and your phone to phone calls work fine. I would suggest making sure that the SIP trunk is Ulaw and make the Asterisk Ulaw as well, not optional of either or. The only other thing is to make sure that the phones...
I am not sure totally about the H323 functionality in this design, as its relational to CallerID. However with the proper minipulation of the RouteList Details, you should be set.
