Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are attempting to setup DMVPN between a 3800 series (3841 I believe) and 2 1841's. Each 1841 will be at a remote site. I've been trying to follow the examples in the dmvpn.pdf document on Ciscos site. Since this is my first attempt at VPN's I re...
I'm trying to recover the password from our IDSM2 and receive this message during the "upgrade". Anybody have an idea why? Initializing the hard disk...Available hard disk space is not sufficient for the IDS upgrade.Failed to initialize hard disk.E...
using a 3825 with the advanced service image I'm trying to route between different subnets but have been unsuccessful. Does this setup look correct?When I do a sh ip route I never see these route showup. I've tried turning on rip and I've tried sta...
2 BR350's OS version: 12.04Antenna: Yagi antennasGoal: Pass traffic between 2 buildings within the same subnet and access the bridges.I can pass traffic between the building fine but I cannot access the bridges after they associate. If I shutdown o...
We have an AS5200 OS version 12.0.(22).Dialups (PPP) connections to this device will work OK for 30min-3 hours then they act like all data over the line just goes into a black hole. The connection on the computer will still show a connection, when ...
I realize this is a month later and this could be new info but it appears groupwise integration is now supported per:http://www.cisco.com/en/US/customer/products/sw/voicesw/products_category_buyers_guide.htmlwes
Bill, I was completely wrong. After more investigation and some trial and error "Everything just clicked" (the VPN and my brain). Thanks for your help. You got me looking in the right direction.Thanks Againwes
I tried your suggestions but they did not work. I think this is a Cisco error because of the following:1. I continue to recieve the EIGRP error message with your suggestions.2. I cut and pasted a config example for the dmvpn document and still recei...
I tried your suggestions but they did not work. I think this is a Cisco error because of the following:1. I continue to recieve the EIGRP error message with your suggestions.2. I cut and pasted a config example for the dmvpn document and still recei...
That is the document I'm using. Please let me know if this is confusing because I'm stuck at the same point with Cisco TAC. The orginal idea was to upgrade to 5.0... I forgot the password so I started a password recoveryIn the middle of the passwor...
