Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have implemented about 30 1200 Series AP's throughout our production facility. We use LEAP to attach to our wireless network. My problem is that I have so many AP's and I have no way of telling which AP I am attached to when on the wireless netwo...
I have a problem with an old AS400 box (maybe 15-20 years). We recently upgraded our routing from a route switch module in a Cat 5000 to a 3750 12G switch. The problem is the AS400 box on the network has the correct IP configuration but nobody can ...
I have a Cisco 7920 IP Phone that is using LEAP. It Authenicates fine to the AP, but the weird thing is that it says it's configuring the IP network (it grabs a IP address), then it downloads the config, and then updates the firmware, and reboots. I...
I have installed the IP Softphone on my laptop and did the necessary configurations on CallMGR setting up the CTI port enabling the check box for CTI application use etc. Now my problem is that my softphone will not work in Stand alone mode (1) and ...
Is it possible to take a cat 5000 with sup III and add the config from a Cat 5000 using a Sup II? I want to upgrade the Cat 5000 with the sup II with a SUP III and start using gigabit.Thanks, RB
I got mixed up on that last question. I can trunk vlans from the 5500 to the 2948G right? Span vlans from the 5500 to the 2948G using a media transeiver on the 2948G? 100FX (5500) to the media transeiver on the 2848G setting up a trunk up in this fa...
Does the 2948G support muli-vlan ports? You mentioned what is the goal for multi-vlan support on a port...My instance would be when you need to use a media transeiver Ex. setting up a trunk between a 5500 and the 2948G. This is being done to to se...
Jasyoung you put me on on the right track. When you wrote "You need to make sure you see and pick the CTI port." The problem is that we have our phones setup to if I'm on call and another call comes in that other line start ringing. To call manage...
For each interface you might want to do this:interface FastEthernet0/2 no ip address duplex half speed 10 no snmp trap link-status spanning-tree portfastAlso make sure IP helper is turned on
