Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Currently i am looking for the upgrade for cisco callmanager 4.1 to 7.xBelow is 3 option:Option 1: One time upgrade for call manager 4.x to 7.x Purchase the following :CM6.1U4-K9-7825=CM7.0-U-K9-7825MCS7825I3-K9-CMC1Option 2:Purchase UCSSMCS7825I3...
Currentlt I have a Cisco 4507 has the following info.Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(40)SG, RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2007 by Ci...
Hi Does anyone has successfully implmement with Cisco Call Manager 4.1 to DEC AScom gateway (IP6000) by implement H323 gateway ?I faced the problem that i cannot call from IP Phone to DEC Ascom Wireless phone.I have no problem call from DEC AScom ph...
Hi, Can anyone advise me on what is the cause of the problem (Manually install 3rd party Vendor for use with WebVPN configuration version 8.0) ?i have follow the configuration example and found this error message via CLiAppreciated any kind reply.FO:...
I have follow the ascom implementation guide on the route pattern by changing values as 8XX which route call from 800 - 899. Pls advis if this is correct and how should i troubleshoot the problem..Thanks
Hi rob, Thanks for your reply.Based on Brandon recommendation the configuration for cisco router and call manager should be correct.Will updated you once finished. Thank both of you
Hi Brandon, I managed to find out the the current 2851 router has only PVDM2-48 installed.I may need 2 purchase PVDM2-16 to support 2 E1 card.Is it correct ? I do not think i need 2 purchase any license as it route to the Call ManagerAppreciated your...
Hi Brandon, Thanks for your prompt reply.Now I faced some error5vgw1(config-controller)#pri-group timeslots 1-31 service mgcp% Not enough DSP resources available to configure pri-group on controller E1 0/2/0% The remaining dsp resources are enough fo...
Thanks for your reply.The switch is a L3 switch(Passport 1200) with access connection (a default VLAN)The interconnection is GigaEthernet uplinkDoes not sure whether trunking works well with Nortel switchesAppreciated your kind advice.
