Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a work group bridge serving 4 non-root bridges. Each NRB has an access switch attached for user access. We are implementing Fortinac across town. For places that are using access switches through OSP to the core, it's working fine. For the w...
I have a cisco ISR4431/K9 running isr4400-universalk9.03.13.02.S.154-3.S2-ext.SPA.bin.
Trying to upgrade to isr4400-universalk9.03.16.05.S.155-3.S5-ext.SPA.bin.
md5 checksum has been verified, config register is 0x2012
rommon version is 15.4(2r)S
...
I had a disastrous IOS upgrade on one stack and I'm researching how to avoid that for the rest of my switches. Last week I noticed that the primary switch was in install mode and the rest in bundle. Today, I have two (so far) different outputs for th...
I'm in a very remote location with poor bandwidth. Let's just say it's about dial-up speed. I don't have any mobile devices, I use a regular old desktop machine. cisco.com is hugely bandwidth intensive and almost unusable for me. Is there a pared dow...
Hi
I have a new ISR4331 and trying to configure per recommendations from a senior colleague.
Suggested config:
voice-card 0/1dspfarmdsp services dspfarmdsp tdm pooling
However, I do not see any dsp parameters under the voice card. Do I need a s...
That does seem the least tricky option. The head office disagrees and thinks we should do the upgrades the way the Cisco documentation says. Perhaps we can do that if I have a stack that has some consistency already. This particular stack is in too ...
Would adding the .bin file to every switch keep it from (seemingly) switching between bundle and install mode? I don't know what mechanism (if any) there is for the stack manager to monitor or modify stack members.
I have to come up with a very det...
I'm not looking to replace them. The DSP's are on the NIM-4FXO. I want to configure 'dspfarm' on the voice card in slot 0/1. There are no dsp options under voice-card config. Is there somewhere else to configure this parameter?
Doesn't the output of 'show voice dsp' indicate that the DSP's are on FLEX VOICE CARD 0/1 and not the motherboard?I'm only slightly familiar with voice configs and hardware, and I've never worked with a NIM-4FXO.The router is very remote, I'll try to...
