About b.shoresh

b.shoresh · 05-02-2011

Hello.We have some implementations of Blue Coat cache with layer2-WCCP configuration on our routers. Now we have a new requirement to configure GRE-WCCP between a Cisco3845 router and a cache-engine, which sits several hops away from the router. Wh...

b.shoresh · 08-02-2007

Hello.I need to measure the actual throughput that goes through the FWSM module. I know it's connected with a virtual EtherChannel to the 6500, but I don't know how can I measure it.Please advise.Thanks.

b.shoresh · 06-06-2007

Hello.I have two FWSMs, running in Failover Active/Standby mode. I would like to run OSPF on one of the FWSM's interface (int vlan2). I have two questions regarding that:1) Will both FWSMs participate in the OSPF, even when the Primary is working ?...

b.shoresh · 05-22-2006

I saw that the 2960 can support up to 256 multicast addresses, while performing IGMP snooping. Is that per interface or per the whole machine ?Thanks.

b.shoresh · 06-30-2005

Can anyone tell me:1) The maximum length of the CAB-E1-DB15. So, If I order the standard cable (of 5m), and I want to make it longer, what is the maximum length ?2) The maximum length of the console rollover cable.3) What is the maximum recommended ...

b.shoresh · 05-02-2011

Hi.The Blue Coat devices are already working in my network. They are using L2 WCCP.We got new cache engines devices (not Blue Coat), for which I need to configure GRE WCCP.Thank you very much for your replies.Boaz.

b.shoresh · 05-02-2011

Thanks Ahsan.So there is no difference between configuring layer2-WCCP and configuring GRE-WCCP on the router ? I can use the same configuration that I've used for the layer2 WCCP installations ?So how does the router know to create a GRE tunnel bet...

b.shoresh · 08-03-2007

Have one question about the issue: is there any throughput/capacity difference between a 1G SFP installed on the SUP720 module and 1G SFP intalled on WS-X6724-SFP, provided that both modules installed on 6509E. Thanks.

b.shoresh · 05-26-2006

The number is 1K mgroup per machine.

b.shoresh · 01-24-2005

Hello.Are you sure this is the link ? I could not find anything, except one show command that shows the ssrc number.

Member Since	‎10-31-2001 10:56 PM
Date Last Visited	‎11-18-2018 12:01 AM
Posts	52

User Statistics

User Activity

Configuring GRE WCCP on Cisco3845 router

How to measure throughput with FWSM

FWSM Failover with OSPF router-is

2960 switch - How many IGMP groups are supported

Cables length

Re: Configuring GRE WCCP on Cisco3845 router

Re: Configuring GRE WCCP on Cisco3845 router

Re: SUP720 with C6513 or C6509

Re: 2960 switch - How many IGMP groups are supported

Re: Configuring the SSRC of RTP packets.