I'm having an issue with Campus manager where Data Collection only runs after a daemon restart, but fails to run consecutive times. I've opened a TAC case and according to them, if you have Access Points on your network, this will cause Data Collecti...
When I run this report on one or any number of devices, the report has all zero's. However, if I run a 24hour report, there is obvious data. Thoughts?We're running LMS3.1, Windows ver, ACS integrated.
Is there a way to run a report that would generate subnet's discovered and cross reference that either the VTP domain or switch cloud? I'm assuming the application that would be able to generate such a report would be Campus Manager, but I can't figu...
I've been trying to build a custom report that shows the information contained in "Detailed Device Report" > Processor Port Interfaces > Port DescriptionThis shows which port has what type of GBIC installed, but I cannot find an attribute in the Cust...
We're in the process of migrating a site from one big flat network to vlans and were wondering how many secondary IPs an interface can have. All that I find online is "multiple". We might need 20-30... TIA
I'm running into a similar situation:We upgraded from LMS3.1 to 3.2 and noticed that CM looked like it was completely empty. ANI reinitialize during upgrade?After noticing this, we ran a Device Collection which appeared to have run properly, then a U...
I should have also mentioned that the report did produce data as of about a week ago, but has suddenly stopped. We have a daily syslog report that emails out events etc. We have quite a few reports from both the standard set and our customized ones. ...