Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've completed the Cisco Live Meraki Switch Challenge and I received the switch. I've followed the link provided by the crew there but once the form completed, no license code is provided. How can I get it?Regards,
Hi, We're planning to migrate our storage from a pair of Brocade 300 FC switchs to some Nexus 5672UP. I'm looking for guidelines on how to achieve this without downtime. Is there a way to connect the Brocade side to the Nexus side and then migrate th...
Hi,
We have a ISR4331 with a NIM-2FXS where a postal meter need to me connected. The PSTN is with a PRI. The postal meter is configured to dial 9 before the numbre that must be reached. When the device place a call we get fast busy and in the debug...
Hi,
I can't find a way to know each members and reload reason on a VSS pair of 4500x. I suspect that the standby peer has rebooted but sh ver only show me the uptime and reload reason for the active peer...
I can find a way to show the vss link up...
Hi,
We're using Expressway configure for MRA. Everything work fine, we can access Jabber IM&P and also phones service with this solution.
But I have a question for QoS. The only setting we have in the C and the E is Diffserv dans put the desired ...
Hi, I've got a Meraki switch be completing the DevNet switch challenge. Now the problem is that I can't receive the 3 years license code... I've followed the meraki.io/mslicense url but after completing the form, no license is provided. How can I rec...
Finally after the Nexus upgrade, which more are you using? ISL? NPV?
I'm looking to achieve almost the same thing as we're looking to replace a pair of Brocade 300 with two Nexus and move also the storage on the Nexus side.
Thanks,
Sh log only show me the ports going down for the standby peer, the lost of connectivity for the VSL etc...and when it come back and sync.
You are right, I see the uptime with show redundancy....is there a way to get the standby peer logs to see the...
