Hi, We're planning to migrate our storage from a pair of Brocade 300 FC switchs to some Nexus 5672UP. I'm looking for guidelines on how to achieve this without downtime. Is there a way to connect the Brocade side to the Nexus side and then migrate th...
Hi,
We have a ISR4331 with a NIM-2FXS where a postal meter need to me connected. The PSTN is with a PRI. The postal meter is configured to dial 9 before the numbre that must be reached. When the device place a call we get fast busy and in the debug...
Hi,
I can't find a way to know each members and reload reason on a VSS pair of 4500x. I suspect that the standby peer has rebooted but sh ver only show me the uptime and reload reason for the active peer...
I can find a way to show the vss link up...
Hi,
We're using Expressway configure for MRA. Everything work fine, we can access Jabber IM&P and also phones service with this solution.
But I have a question for QoS. The only setting we have in the C and the E is Diffserv dans put the desired ...
Hi, Is there a way to access the collab sandbox with an hardware vpn box? I only see Anyconnect instructions. It would be great to be able to acces it by connect with Hardware IPSec VPNThanks!
Finally after the Nexus upgrade, which more are you using? ISL? NPV?
I'm looking to achieve almost the same thing as we're looking to replace a pair of Brocade 300 with two Nexus and move also the storage on the Nexus side.
Thanks,
Sh log only show me the ports going down for the standby peer, the lost of connectivity for the VSL etc...and when it come back and sync.
You are right, I see the uptime with show redundancy....is there a way to get the standby peer logs to see the...
Hi,Support is already engaged on this, I'm waiting for the level 2 answer on this.I will post the capture of the both commands asked tonight when I will have access to the system.Cheers.Mat