Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,
I have an issue in setting up two DNAC appliances in 1+1+1 setup. our Software version is 2.3.3.6. I cannot pass the DR validation as it is complaining cannot ping Recovery's Ent VIP.Currently pings to the all the Recovery VIPs from Wi...
Hi!
Which IP address does DNAC use for Automation and Assurance backups?
Is it Enterprise VIP or the node's individual Enterprise IP address? or perhaps Management VIP or individual node's GUI IP address?
Thanks
Hello,
How can I check which version of DNA Center software is installed on the the appliance prior to configuring the appliance using maglev Wizards?
Thank you
Hi team,
I am trying to configure DNAC MAGLEV Cluster Virtual IP addresses.
DNAC version is 2.1.2 2ndGen, appliance is DN2-HW-APL.
According to the installation guide "By default, Cisco DNA Center configures a link-local subnet (169.254.48.0/20) for...
Hi everyone!
Having issue with upgrading from 3.4 patch2 to 3.4 patch 3.
problem Summary:
Two-node deployment
Upgrade via GUI – Upgrade & Rollback method.
Secondary node was not deregistered before upgrade.
Prerequisite checks passed, but upgrad...
Hi @PabMar
Thanks for the response.
One paragraph below on the same installation guide says:
Cluster Subnet: Identifies one dedicated IP subnet for the appliance to use in managing and getting IPs for communications among its infrastructure services...
Thank you Mike and Thomas,I noticed that if CRL download is not successful you will get an alert in the Dashboard. In addition in the RADIUS live logs (depending on your config for the specific trusted certificate) , after "ISE will continue to CRL v...
