Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we were running a pretty old version of the Cisco Secure ACS for AAA our network devices.Unfortunately the server crashed an we had to install and set it up with a new server.Using TACACS+ for our Cisco devices works fine.We have a couple of s...
Hi all,we are planning the installation of ~300 duct mounted switches in a building with an existing fiber to the desk cabling (62,5µm) in order to implement VoIP with PoE.The duct mounted switches have 4 RJ45 ports, 1 RJ45-Uplink and 1 SFP-Uplink.U...
Hi all,I am trying to create a configuration compliance template using LMS2.6/RME4.0.Here is the template:--------------------------------------------------------------Name: Global SubMode: No isPrerequisite: No Ordered : No Prerequisite...
Hi all,I've been trying to analyze the Auto-QoS-Config of a Catalyst 2960 and there is one command I don't understand:mls qos queue-set output qset-id threshold queue-id drop-threshold1 drop-threshold2 reserved-threshold maximum-thresholdWhat I don't...
Hi everybody,I have a problem with multicast-routing:We have 2 Core-Switches running sparse-dense-mode and auto-rp. The streaming device has its own VLAN and is directly connected. Client-PCs in other directly connected VLANs can receive the stream.W...
> lease try using ip tacacs source-interface How do you do that?As far as I see you can't assign IP-addresses as source-interface (at least with IOSs we're using):ip tacacs source-interfaceTo use the IP address of a specified interface for all outgoi...
Hi Alan,if you want to implement a L3-access design, there are some recommendations:- implement OSPF or EIGRP- use stub areas- implement summarization- implement equal cost routing for your uplinks- tune routing-protocol timers to achive very fast co...
I'm not sure, but this looks like a possible solution:https://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoSDesign.html#wp1002426
Finally I found an information regarding the maximal number in the Release Notes for the Catalyst 4500:"Ensure that the sum of the logical interfaces across all instances of spanning tree for different VLANs does not exceed 3000 for the Supervisor En...
