Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I was strugling with this for some time now, been researching the Internet and reading documentation and white papers.But still haven't been able to find a solution. I am hoping someone on this great forum may have experienced this and know of ...
Hello everyone
Would anyone happen to know of any tips/tricks or commands to lower the Fan speed in the ASR 1002 Router. The noise is defining, sounds like a Jet Fighter engine. Especially at first power-up. Then it's even loud when it shifts to se...
Hello/Greetings
Question for you. I have an ASR 1002-F Router. With the standard 4-Port 1GB SFP ports. Management Port and Console Port.
Wondering if anyone knows or are using the Management port for something other than management.
Here is my sc...
Hello. I'm trying to setup a Port-Channel (or EtherChannel) between my ASR 1002-f Router and 3570X Switch.I need to pass VLANs 10,20,30 & 40 over the Port-Channel (This is why I set the Switch ports as Trunks)
Need to confirm if this is the correct a...
Hello. I'm trying to setup a Port-Channel (or EtherChannel) between my ASR 1000f Router and 3570X Switch.I need to pass VLANs 10,20,30 & 40 over the Port-Channel (This is why I set the Switch ports as Trunks)
Need to confirm if this is the correct ap...
Hi Rasika Thanks again, much appreciated. We will most likely upgrade our older ASR 1002-F Router as well (Just to cover all bases)We were looking at the ASR 1001-X or the ISR 4451-X (The whitepapers say these routers are capable of up to 2gbit data ...
Hi RasikaAgain, Thanks so much Here are my iperf results iperf>iperf3 -s -i 1 (Getting OUT OF ORDER results)Server listening on 5201-----------------------------------------------------------Accepted connection from 192.168.4.21, port 63531[ 5] loca...
Hi Leo Here is the switch (5520 Controller Port) config:SNI510SW001#sh run int te1/1/1Building configuration...Current configuration : 179 bytes!interface TenGigabitEthernet1/1/1description WLAN 5520 Controllerswitchport trunk native vlan 20switchpor...
Hi LeoThanks again. Here is the Switch (AP Port) configs:SNI510SW001#sh run int te1/0/13Building configuration...Current configuration : 124 bytes!interface TenGigabitEthernet1/0/13description WLAN Access Pointswitchport access vlan 40switchport mode...
Hi Rasika I hope your well Just wondering if you may have any additional suggestions and/or information which may help me with this issue.Thanks again, much appreciated Cheers
