Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allNot sure if this is the right place to put this post but I just wanted to know whether it's possible to monitor the usage of the switch fabrics on a Catalyst switch or not. I know that I can monitor and collect statistics for individual interfa...
Hi allI read this document on configuring MS L2TP VPN with ASA firewall http://www.cisco.com/en/US/docs/security/asa/asa72/asdm52/selected_procedures/asdml2tp.html using ASDM. At the half way mark, there're comments on how to configure Tunnel Group S...
Hi allI was wondering whether it's possible to define a same subnet that exist on both the inside and outside interfaces on a PIX 515 running ver 6.3(4). For instance a subnet of 10.10.1.0/24. I'm setting up the PIX to receive RIP routing update from...
Hi allAttached is a pdf diagram showing I've stacked together 4 x Catalyst 3750 switches. It's working fine at the moment but if the power to one rail is lost, the complete stack is broken. Hence I thought of moving the power connection in the 'New S...
Hi allI'm in the process of finding out more detailed technical information on how video conferencing is implemented by OCS 2K8. Things such as typical bandwidth usage, protocol, accepted level of delays etc. What's more important are sample configur...
Hi thereJust letting you know that I've been tasked for similar report/documentation from the business. just wanted to know how you went and may be you can share the information/documentation if possible. Greatly appreciate your response on this matt...
OK, I found my own solution and thought that I'll share the knowledge with others.The only way I found to get this working was to wipe the VPN config and start again.1. First, make sure that you'll get your MS L2TP clients working. I only need to mod...
More information on what it is that I'm trying to achieve and found.Objective: Allow multiple MS L2TP connections from multiple users. The users are programmed to obtain different IP addresses from different IP Pools so that ACL can be applied approp...
I think you're right about not adding the PC to the domain. I normally build the PC at the office, got the user to actually log on inside the internal network so that the account is cached onto the PC. Then take the PC out and VPN in. Start before lo...
I've received an answer from a PIX/ASA engineer working at a large telecommunication organisation stating that it's quite alright to configure passive RIP on the inside interface and a floating static route for the same subnet/s on the outside interf...
