Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hii have 2 controllers 4404 and 2 buildings my problem is when i m using the cisco phone 7921 and i move from building A to building B i loses the voice for 2 - 3sec but i still see the call is there.i did some search and i configuer the mobility gro...
hi .. i have a 3560 switch and all port are configured as access mode except the gig port is configured as trunk now when i do show runn i see new commands on the fastethernet portslikeswitch port mode trunk my ios image is c3560-ipbasek9-mz.122-46.S...
hi i have a a switch with a corupted image on it, i did the steps of sending a new image through the xmodem ..but i booted from the new image i got this msg--------------------------Loading "c3560-ipbasek9-mz.122-25.SED1.bin"...c3560-ipbasek9-mz.122-...
thank u , i did what u said befor .. but i upgaraded the phone to the 1.3.4this is the out put for the command show mobility summary(Cisco Controller) >show mobility summarySymmetric Mobility Tunneling (current) .......... EnabledSymmetric Mobility T...
hi againis the mobility config is to add the mac add of controller A into controller B and Controller B to controller A ??in the doc there is a multicasting .. but i don't know the multicasting group IP address ...??regards
i think its up i ll check this one.i think its a L2, both controllers are connected to the same core switch they have the same vlan for the voice but the diffrence is in the ap manger subnet.
thx ppli have attached two files ,first i have erased all the config then do multiple show runn please see how new thing is coming under random ports (the file is befor config)thin i configuerd the switch with some vlans and connect it to another swi...
