Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 2800 series router which is currently functioning as an internet router. I want to extend it functionalities as a VPN device (both Site-To-Site & SSL VPN's) as well. Do i just have to buy a security license from Cisco and it will support ...
Hi,I have a UC-560 Box and for some reason it doesnt allow any 800 or 600 numbers above 7 digits and is matching the wrong dial-peer. I have tried all from my side but in vein.For example if I dial 800200200 it will auomatically translate to 8002002 ...
HiI have a new client requirement on Cisco CME like - all International Calls should get disconnected after 6 minutes. Is there any way to accomplish this ?ThanksNabil
Hi. I have two Cat6506 (redundant collapsed-core config) configured w/ RPVST+ and connected to this are a series of Cat2950s configured with PVST. My question is, is this a good practice configuration of STP? If not whats the best practise .What I...
Hi. I have two Cat6506 (redundant collapsed-core config) configured w/ RPVST+ and connected to this are a series of Cat2950s configured with PVST. My question is, is this a good practice configuration of STP? If not whats the best practise .Wha...
Hi Paolo,Thank you for the response but unfortunately its not about the dial-plans as you suggested. I have setup all dialplans properly ncluding 9T) and is working fine (you can go through the configuration file I have attached). As suggested by Dar...
Hi Darren,But how come its matching the wrong dial-peer when I have a specific dial-peer for 800 number. In-fact the dial-peer for 800 number is having a better preference also. This is completely against the noemal logic and is what confuses me .
Dear Anu,1 more doubt if I have an ASA+Websense setup and if I configure the ASA excatly as if there was an ISA will it work (meaning I dont want to use any "Filter URL" commands) ???
