Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running a WLC with 7.3 software and I have configured a Rogue Detector AP. The CAPWAP tunnel between the Rogue Detector and WLC is up and the system sees the Rogue as an AP. The Rogue is on a Trunk port which has a Test Rogue AP, I also Have an A...
Is the subject line status correct? I have a gigabitethernet port (3845) that went from admin down, to reset and then status Down, protocol Down. Then I had another gigabitethernt port on a different 3845 router. To show port in status of UP and prot...
We have new cisco ip phones which will be installed, about 2000 phone to our existing network. We noticed that when we install phones with the power cube adapter and then connect the POE switch port last that the phones take power from the cube and n...
Hi,If for some reason the switch is in Half Duplex on those ports. Both access port of the switch and the connected device must match . AUTO/AUTO for both or Full/100 , Full/1000 for Both .
I have the same issue, my Rogue Detector that I configured has an Admin Status of down . Cisco can you answer if this is correct and due to the radio being not used ? This post was never marked as Correct .
The link that Ven sent is all you 'll need, just remember you'll need to identify your source address with the FW that you need the data to go out.Jeff JohnsonFrom: "ven.taylor" To: jefferyj40 Date: 03/08/2012 07:25 AMSubject: - Re: ...
Yes policy routing is the answer, you basically have two default routes to the Internet. You need to have the route maps take traffic to FW1 and have it as next hop on your route map statement on the 6509. Then you would do the same thing for the tr...
