I'm running a WLC with 7.3 software and I have configured a Rogue Detector AP. The CAPWAP tunnel between the Rogue Detector and WLC is up and the system sees the Rogue as an AP. The Rogue is on a Trunk port which has a Test Rogue AP, I also Have an Active Local AP near the Rogue and it does detect the Rogue AP MAC. However, the Rogue doesn't detect that MAC on the wire and it is there. I have noticed that the Admin Status of the Rogue is in a Disabled state. This may be due to the fact that the radios are not used in this mode. Is this the correct status and any suggestions on what is going wrong here. The MAC which is showing on the Switch trunk is -1/+1 from the MAC which shows the Rogue AP on the trunk port of the switch that the Rogue is connected. But the Rogue Detector doesn't seem to see the MAC or act on the fact that it is on the Wired Network.
