I am currently using a CiscoSecure ACS server to authenticate PPTP clients to a VPN 3000. The documentation states you enable PPTP by editing the Base Group on the VPN 3000. But I want to use separate IP address ranges for different users to apply ...
I recently installed a 4402 Wireless LAN controller with 19 lightwieght APs. I use 802.11 authentication with WPA2, AES and PEAP through a CiscoSecure ACS server and a Microsoft 2003 Active Directory. Everything works fine except when I need to pas...
I see the error message "dot11_mgmt: bad cookie returned from driver" when clients try connecting. What does this mean? I cannot find any documentation for this error message on the Aironet 1231.
I upgraded to LMS 2.5 and I was able to see Campus Manager and RME in the Device Center. After rebooting the server, I open Device Center and it says "No applications or devices found"
PIX 515 doesn't recognize 128MB DIMM. Will only recognize as 32MB. Also when upgrading to 7.0, I get an error message that there is insufficient flash, but I have the required 16MB of flash.
I downgraded my client to 2.3.0254 and still got the same result. What fixed it for me was adding the address pool to the tunnel-group DefaultWEBVPNGroup. When using the VPN wizard, the wizard asks you to create a tunnel group and assigns the addre...
The guide helped, but was incomplete. With the help of TAC we figured it out. In order for CiscoSecure ACS to point to a different group on the VPN 3000 Concentrator, you have to enable RADIUS IETF attribute #25 and specify the group name on the co...
Thanks, for the info. Now I understand the NAT part, but I just a little more on the static command. Outside users were able to access our web server with its public IP address without a static translation statement. I only had a access-list in pl...