Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure IP SLA opertation for DNS quaries. This IP SLA operation has to be VRF aware. I conld not see any configuration example in Cisco documentation for VRF aware IP SLA for DNS or HTTP. is this a limitation or is there any way to ...
MPLS PE and P routers are connected using POS link. MTU size of all the core routers are 4470. When I ping the loopback ip address from one router to other router, It allows only maximum 1546 bytes of icmp packets with fragmentation. Is there any max...
In my network, one 7600 with PFC-3BXL mode runs MPLS. Now I need to install a card which belongs to CFC mode. In that case what will be the opration mode of 7600 and is there any affect on mpls feature?
Two same type of access devices are connected to the two ports of a switch. Uplink of the switch goes to a MPLS edge router. The access devices are shearing some common vlans of edge router. When the devices communicate between each other via common ...
Hi Laurent,If you supervisory is PFC-3BXL then the working mode of 7600 is PFC-3BXL. But if you install an line card with DFC-3A then the working mode is PFC-3A. This will not support mpls. This is explained in the cisco documents. But If the line ca...
Hi Giuseppe,Thanks for your reply.SW3 will be a stack switch. Multicast will be in global routing table. Our aim is to give fault tolerance at access level.Regards,Senthil
In 7600, When you xconnect you use encapsulation mplsxconnect 10.0.0.1 200 encapsulation mplsIn 2600, When you xconnect you use encapsulation udpxconnect 10.0.0.1 200 encapsulation udpif i want to xconnect a circuit from 7600 to 2600 how can i do tha...
