Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For Admin Groups, it is associated with an existing External Identity Source which is an AD.I wish to change the External Identity Source of the Admin Group to another AD which I have already joined under External Identity Sources.How do I do so? Tha...
I configured Embedded Packet Capture on the following trunk port. The pcap file shows TCP unicast traffic which should not traverse through this port. The IP addresses in the ACL belongs to vlan 636. The neighbour switch connected to Te1/1/14 does no...
It seems that capturing on physical interfaces configured as L2 does not capture any IP traffic packets. It only captures STP and VRRP traffic etc.However, if I capture based on the vlans instead, I can see IP data traffic being captured, but capturi...
I have a 9300 switch with an Essentials license. It has a limitation of 1000 OSPF routes.Will there be a log to indicate that this limitation has been hit? I could not find any information on this.When I do show ip route summary to check the total nu...
Hi all, are there any Cisco AP models with downtilt internal antennas? I checked through a few Cisco 9100 series APs data sheets but did not find any.I see that Aruba has such APs, and it appears to work well in difficult environments without resorti...
it is due to the essentials license limitation, not the hardware.https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9300-series-switches/nb-06-cat9300-ser-data-sheet-cte-en.html#Softwarerequirements
I do not see any logs related to exceeding OSPF routes limit.. It could be only shown at the start when OSPF was enabled. I am not sure.Oh thanks, what do you mean by summary? I configured a default static route 0.0.0.0 0.0.0.0 192.168.3.1, but I am ...
Thanks all! Please ignore the command output in my question, I took it from a Cisco Reference page as an example.The total number of prefixes is 2948 when I do show ip ospf dtatabase.show ip ospf shows AS LSA as 2948 as well.From show ip route summar...
