Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WS-C3750-24TS-S switch that I am trying to upgrade the flash files. I have downloaded a few different versions of the CatIOS with the GUI files. The transfer fails everytime. Here is the error log:Switch#archive download-sw /overwrite tft...
My company has a site where we have debated the difference between installing a T3 vs 50Mb Ethernet.We typically deploy 3845's in this scenario. T3 prices (monthly cost & hardware costs) are not cheap and ethernet (especially with inexpensive hardwa...
I am not sure if this is the right forum for this, but here goes.I am looking for older Visio stencils for the 3508G-XL switch. The current set of stencils only includes the 3550 series switches within the 3500XL .zip archive. Does anyone know wher...
Greetings all,The company that I work for has purchased another company and we both share common subnets. We are thinking of using NAT in the meantime (instead of re-addressing) during the transition.We plan on using IOS Nat with a router, probably ...
Does Cisco have tool available to customers that would allow us to put in a number of a device (serial, model, smartnet, etc) and return the current status (End of Sale, End of Life, etc.)?My boss is looking for a quarterly report that can be generat...
RESOLVED:The issue is with the command:archive download-sw /overwrite tftp://10.0.0.2/c3750-ipserviceslmk9-tar.122-52.SE.tar flash: The destination file is not needed.archive download-sw /overwrite tftp://10.0.0.2/c3750-ipserviceslmk9-tar.122-52.SE.t...
I followed this to the letter:%Error opening flash:update/info (No such file or directory) The switch reports this error message during the software upgrade:Stack_Switch1#archive download-sw tftp://1.1.1.2/c3750-advipservicesk9-tar.122-25.SEE1.tarCou...
Now I think I understand the difference. The switch will shape down to Layer2...whereas the router will shape on L3 only.Thanks for the reply. This is so confusing, because it seems like all the devices (even regular switches) shape with SRR comman...
The 7960G is supported:http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme71spc.htmSIP Loads:P0S3-08-6-02.loads*P0S3-08-6-02.sb2P0S3-08-6-02.sbnSCCP Loads:P00308000500.loads*P00308000500.sb2P00308000500.sbnMake sure you have do...
I believe you can use the following command to accomplish what you seek:Router#configure replaceI have used this with success to rollback changes. This is how it would work. If the new config was in flash:, then it would look like this:Router#confi...