Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I hope this is in the right forum.
We have a Cisco CallManager 8.5 connected to a Nortel PBX.
To dial out from a Cisco IP phone >> CallManager >> PBX >> PSTN, it is set up to dial 68.9XXXXXXX for a 7 digit local call.
Somehow I need to magically tra...
we have two eem scripts configured to look for a syslog event tracking a VRRP change. They work great! However we have run into an issue that has occurred 2 times now where the VRRP flapped within a millisecond time frame. As a result, our router ...
we have 2 call centers - geographically separated. Both running off same call manager 8.5 cluster and uccx 8.5 cluster. both use cisco 7962 phones, with extension mobility. plugged into cisco 2960 switches. pc's plug into the phones. issue is tha...
We have remote sites that have 2 routers, the backup router is a cisco router that connects to MPLS and uses BGP. The primary is a fortinet 4700. We are using VRRP that prefers the 4700. We have other remote sites with only MPLS. If we do a "redist...
Found a helpful thread here about how to get Caller ID working when forwarding a call.Given this scenario -User A has an phone number of 555-555-1234User A forwards his IP Phone to 555-555-1212.When User B 555-555-9876 calls User A at 555-1234, the ...
https://supportforums.cisco.com/document/48891/cisco-eem-best-practices#comment-10900291
so there's my answer. we increased the # of login's of the eem script (increase line vty 0 1) at the expense of one of the interactive vty lines. Easy choice f...
i'm just finding this and the usefullness of EEM Scripts.
One question, if you lock the applet to use a AAA user and lock it to VTY 0, and then discover the need to run more than one applet at the same time, is it possible to follow the same direct...
Great info! thanks Joe.
I think that we locked the router down and prevented multiple applet threads to run. So just made change to allow it to login more than once. We will see if that helps.
as mentioned in my original post the phones are cisco 7962's sccp phones. we have used cable testers on the cables they test out fine. today the port did not err-disable but the phone stopped working. other times the port has err-disabled.we have no...
nothing helpful logs. since we had 2 phones err disable today i was able to pull both logs. sometimes a shut/no shut will not enable the port and we have to reboot switch. today we were able to just shut no shut. but phone did not register or work...
