Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
we are using PnP in order to setup a large number of IE4K/2K switches on sites geographically dispersed, with minimum onsite technician intervention, considering it has low networking knowledge.
Our tests are successful but we have some open ...
Hi all,
I've implemented a back to back vPC on a data center network by using 4 Nexus 9372X distributed in two different sites. Each couple of distributed Nexus corresponds to a vPC domain and auto recovery feature has been configured on it. 2 Nexus ...
Hi all,
I'm trying to find a solution to the need of activating several features on Nexus 9372-TX that are not considered by default. As I understood, enabling non default features require TCAM carving, corresponding to sacrifize space/slices from a ...
Hi all,
does anyone know if it's possible creating a port channel mixing fiber port with copper one?
With Catalyst series I know it is, but with Nexus I'm trying to create a channel group aggregating port Eth1/48 (10Gb copper) with Eth1/52 (fiber wit...
Hi all,I'm trying to figure out which is the less risky way to interconnect 4 DC, starting from a customer's requirement (arguable) and the limitation of hardware already chosen (not by me).This is the actual scenario:2 sites (DC1 and DC2) L2 inter...
Thanks for your answer,
but these are my doubts that remain:
1) I need to know if it is natively possible to disable logging for the operator using PnP app
2) I was in doubt, because I think the configuration is normally pushed to the mobile thanks t...
Sorry to be late in giving feedback.I confirm that on Nexus 9300-TX channeling between ports of different media is not possible and this is what the system returns:NX_BF1_Pri(config-if)# channel-group 105 force mode active command failed: port not co...
Thanks Andrew for your answer, just a piece more in order to well understand: by saying 'gracefully settle the condition without going dual-active' do you mean that units remain in their state? Chiara
Thanks for your answer, but I don't know if you well understood what I'm trying to do: I want to monitor an external Ip reachability, not a route inside routing table. Something like:ip sla 1 icmp-echo external_IP source-interface FastEthernet0 timeo...
