Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have a consistent way for me to test throughput on a routed SG-300. I tried using iperf with netbook on VLAN1 to netbook on routed interface running @ 100mb. I was getting results as low as 40mb upto 200mb (sometimes even 2gb, I assumed...
Hello all. I'm a realatively green BGP person. I've done one other BGP implementation before, but I had full control of the environment - owned a direct assigned block of IPs from ARIN, registered my ASN with ARIN, etc. I am now working with a cus...
Hello. I'm trying to a PRI while it is also registered to CUCM (long story as to the need for this). I assumed this would not be a problem, but I cannot get it to work, so can someone clarify? I can neither use csim start nor isdn test call effect...
I'm trying to traverse from my inside private IP address (10.x.x.x) to my public IP address translation (172.16.x.x) in order to take advantage of the ACLs that are already applied on my outside interface. For example:Host 10.0.0.1, translated to PA...
Hello all. I want to provide full network redundancy to the internet. I have the following equipment:7204VXR /w NPE-G1 - Internet router(2) Catalyst 3560 - DMZ/Outside switchs (seperate VLANs)(2) Pix 535 - Firewalls(2) Catalyst 6509 /w Sup720Ultima...
Thanks for the replies. I think the issue is unrelated to the SG now, but jperf looks great! The switch is running 1.2.7.76. I took the switch, disconnecte everything, and plugged my laptop in at the far side and tested throughput across the link...
Hi aokanlawon. Thanks for following up! I think at this point it's just not worth the amount of time it will take in order to generate this test environment. I appreciate yours and everyones help though.
I've applied the bearer-cap speed to the voice port as well as "no isdn bind-l3 ccm" on s0/1/1:23 just to test:Jul 9 10:23:25.881: ISDN Se0/1/1:23 Q931: Applying typeplan for sw-type 0xD is 0x2 0x1, Called num 55555555555Jul 9 10:23:25.881: ISDN Se...
I mentioned it being a long story.. - this is the synopsis..The router currently is registered to CUCM. The company is moving to a new location, but wants to verify the PRI as operational before they move. So, they're going to take one of their ...
Hi Varun. This command will work on a one-to-one server basis, but my issue is that I have about 300 servers that I need static translations for, and while I can create these translations, it's a bit more administrative overhead than I wanted, espec...
