Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all, we currently work on getting some new uplinks to our building. As part of our existing network, we have a customer link with 1 gig fiber using MPLS that is just patched through to our customers endpoint. Due to the new uplinks, this connect...
Hi there,
on Prime 3.1 under Monitor / Monitoring Tools / Alarms and Events / Events -> All I can see a lot of "VPCs are in Consistent State" messages - every 15 minutes. However, I only get these messages from one of our Nexus 5ks (we got multiple s...
Hello,
we're using Prime Infrastructure 3.1 and had an power supply failure at one of our 6509. Sadly, Prime did find out about this problem (I saw the error if I switched to the device view, env details) - but it did not send an email, nor raised an...
Good evening,I am working at an local University which supports wired eduroam. Wired Eduroam uses 802.1X with EAP-PEAP and MSCHAPv2 as Second Phase. I wanted to ask wheter it is possible / and how to configure an ASA5505 as wired 802.1X Client on the...
Yes, I would only put both the 1gig and 10gig Fiber with the MPLS connection in one VLAN and keep all other traffic on the switch on different vlans, so that the MPLS connection is not disturbed by any other traffic.
Hey Paul,its a bit more complex, the new connection is a single/monomode fiber with a 10 gig SFP+, the receiving end is a 1 gig SFP with multimode fiber and SFP. We cannot change the SFPs or wiring, but we luckily got them both at the same location a...
Thanks BB,I am completly new to MPLS and never have used it (just having this fiber accidently running MPLS, but its just a black box) - and the first searches I came across showed MPLS somewhat connected to BGP - so the question would probably be fo...
Hi Marce,
so Prime does realize that an power supply or such failed via the normal SNMP/Telnet checks, but it does only give E-Mail alerts if it gets these errors via snmp-trap? (And I have to configure snmp-trap on every device?)
Nico
