Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,We have recently implemented Windows Deployment Services on our local network, but everytime we do a multicast image deployment the network get flooded to point of total saturation.We have Netgear switches and a Cisco 2800 series route...
Hello,I have a Dell Latitude E6410 laptop that does not have a Serial port or a Break key on the keyboard. I have a Prolific PL2303 USB-to-Serial adapter which is installed and I can access the CLI ok with this setup via HyperTerminal.My problem is t...
Hello,I was just wondering, what the Loopback LED does when it is on. Also, I have not been able to get this LED to turn on. Please can you tell me how I can get this working.Also, is the VPN capability only included if I upgrade to another version o...
Hello,As you may have seen in a previous post that I have created, I had another Cisco 1801 router that was deemed to be faulty. Therefore, I have managed to buy another, however on this router there is a small hole/button to the right of the Compact...
Hello,I was just wondering if it is possible to setup Link Aggregation between the switch ports on a Cisco 1801 Router and a Catalyst 2950 switch.Also is it possible to set up link aggregation between a managed switch and an unmanaged switch?Thanks.J...
Thank you to all of your replies. I am currently away from any Cisco equipment until next week and will try it and see if it works.Can anybody recommend any specific USB to Serial adapters that work well with Cisco equipment or does it not matter. I ...
Hello,How do I take advantage of the using this loopback feature because i have set Dialer0 to loopback however, this does not seem to be working - I get no light up after setting this option.Thanks.Jonathan Worth.
Hi,Sorry for the delay in replying. I have just opened up the Cisco 1801 Router and have found that the memory socket on the motherboard(?) is empty and was just wondering if this could be the cause of the problem?If there is meant to be a stick of ...
Hi,I have upgraded to: (C180X-BROADBAND-M) Version 12.4(24)T3The System Bootstrap version is: 12.3(8r)YH8.Still getting intermittent pings and high output errors:Router#show interface fastethernet1FastEthernet1 is up, line protocol is up Hardware is...
