Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi team,
We have just upgraded our ASA 5525-X firewalls to mitigate the IKEv2 bug that has just bitten this platform. The TAC supplied image was 9.14(4)24. As soon as the firewalls came back into service we noticed we were getting odd SNMP polling re...
A new CCM installation is in place. Receptionists are rebelling against PC based apps, as they already have a number of apps running already. They want to be able to see the line status for a user before transferring the call. If they have a shared l...
Thanks for making a suggestion. Yes, they are an HA pair but the system-id did not appear to be the issue, we were getting partial responses rather than no response. I would expect system-id mismatch to break rather than degrade responses? Prepared t...
Thanks for the suggestion. Unfortunately entering the command resulted in Error: WLAN <your_wlan_id> enabled. My struggle is with an older facility we have inherited running a pair of 2504 WLCs with a mixture of 1532, 1562, 2702 and 2802 access point...
Hi,
I suspect the issue is not with the wireless side but with the switch side. I'm working on a similar issue at present and it appears that, when in flex connect mode, the client associates with the new access point but the switched network doesn't...
I am interested to know if the upgrade remains successful as the bug information is not that helpful as yet. Please can you advise if it proves effective or if the problem recurs?Thanks,Mark
On the router:interface wlan-ap0 ip unnumbered Vlan1interface Wlan-GigabitEthernet0 switchport mode trunk On the access point:dot11 vlan-name <vlan> vlan 4! replace <vlan> with your VLAN name as used on router for consistencyRemove bridge group 1 fr...
