I have stub routing configured for some of our remote routers. One of the perks of stub routing is that you don't have to have a full route table at the remote router. All you need is a default route to the distribution router. I have not found a wa...
Hello all,I am new to Cisco's wireless products. I have never seen or touched any Cisco wireless products. I use a Linksys wireless router at the house, but would like to repalce it. I was thinking of replacing it with a Cisco WAP. The reason I want ...
Hello all, I am studying for my CCNP and am going through different scenarios on my testebd at home. I am trying to perform route summarization on a few subnets I have configured to some loopback interfaces. I have the following IPS:Loopback0 - 10.0....
I am new to VoIP, and am wondering what software I need on my router to run CME. Is it possible to have CME running on a router that has the vpn/firewall/ips IOS on it? Do I need anymore software on there to make VoIP work? I have 2 FXO and 2 FXS car...
What is a VIF, and why would I use it? I have heard people talk about it, but I am not sure what it is used for. It appears to be used in conjunction with multicast. I could not find any good articles on the web that talked about it.Thanks,Tim
Jon,Thank you for the information. It's funny how you can spend hours surfing the web and not find any answers to your questions, or you can post a topic in a forum here, and get it answered in about 20 minutes. So thanks again.Tim
Jon,Thanks for the reply. We do not have a default route in place, we use EIGRP to perform all routing. Because we have multiple redundant links for all of our distribution routers, it would be somewhat cumbersome to use default routes, and redistrib...
Hi Jim,If I recall, and someone correct me if I am wrong. But you will need to have a 2600XM router to support the k9 IOS's. This is due to the memory restrictions on the 2600 routers. They only support a max of 16/64 flash/dram. You will need a 2600...
When using the extended ping command (ping [enter]), in order to specify a source address or interface you need to hit y when asked about extended commands.hth
Let me start off by saying thank you to Eric and Rob for taking the time to answer this question. I already have a router to perform the routing (5 in fact (I love my testbed)):). Now, as far as configuring it, Eric you covered that. Thanks. About th...
