Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a cisco validated config for exposing a SX20 unit on a router? I have a 2911 router.
I don't have a firewall at the site.
I know I can nat the device and enable the following incoming ports the on public ip
udp 1719
tcp 1720
tcp 5555 6555...
Looking at the reports on Ironport, I see that a certain IP was stopped via the reputation filter. Is there anyway in the log to see why it was blocked? Would it be under the bounce logs or the mail_logs?
Is there a way to tell if a source fire device is blocking without the use of defense center? We have run into a few issues where the device will stop passing traffic or is blocking traffic, but there are no logs (eventhough they are set to log). Is ...
CPAM client running very slow..Any troubleshooting tips? Remote site with 20ms just crawls. Firewall is open. Is there a document that helps with troubleshooting client side issues?
Ahmad,I'm new to video and had a few questions as I'm having this issue too.You say to have an allow lise to block illegimate registrations, is this under vcs -> registration -> allow list?
Thanks!!The reason I ask was that I have it under TMS and I'm getting these alerts saying that I need TMSAgent and all this stuff. I clear them, but it doesn't go away. I didn't have it running there, but I was wonder how to get rid of it.I'm runni...
