About 1aindyin2

1aindyin2 · 10-02-2007

Is there a way to setup port security so that our laptop users can plug into the lan in multiple places around a building while preventing outside users from coming in and doing the same. Purhaps a table of pre approved mac addresses that the switch ...

1aindyin2 · 07-24-2007

Is there anyway to determine the total amount of memory installed in the Standby Sup2-2GE on a 6505.

1aindyin2 · 07-13-2007

We have a c6506 that we changed the IP addresses on, after that the device disappeared from the LMS 2.6 device lists. When we tried to re-add it we get an error saying you cant have duplicate names. The device does not show-up anywhere in CW LMS. I...

1aindyin2 · 06-11-2007

After we upgraded ACS to 4.1(1) Build 23 from 3.3.4 we no longer are getting information in the TACACS+ Administration Report Files. aaa new-modelaaa authentication fail-message ^CC Login Failed, Please Try Again.^Caaa authentication password-prompt...

1aindyin2 · 01-29-2007

What does the check=2 mean in this ACL match result? permit XXX.XXX.XXX.0, wildcard bits 0.0.7.255 check=2ThanksCharles

1aindyin2 · 03-12-2009

We had the same issue happen when we pasted a new login banner on our 3750 switches after upgrading to to 12.2(50)SE. Switch locks up during paste of banner. What code did you put on the router?.

1aindyin2 · 01-06-2005

You can copy the topology view you want to use to other users. All views are saved in individual user folders located under:C:\Program Files\CSCOpx\campus\etc\usersFind the view you want to use and copy it into all the other user folders.

Member Since	‎01-06-2005 01:09 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Port Security

Standby Sup2-2GE Question

Device error in LMS 2.6

TACACS+ Administration Reports Problem

ACL matching results

Re: after configuring login banner router is not acessible

Re: Campus manager Topology Views