We have a scenario where we have VLANs spread through VDCs on a pair of 7Ks, one VDC running MSTP with 3 instances and another running RSTP. We are then connecting some 3rd party switches for a DC environment that are running PVST.
Root guard tr...
Hello,
I am looking to change the IP address range used by the management interfaces of the 7 WLCs in the organisation.
WLC1's Ip address currently responds to the CISCO-CAPWAP-CONTROLLER DNS Entry.
My questions are, when an access point communi...
I'm currently taking routing updates from our SP for our new MPLS. We currently have other circuits providing data services to the sites we are migrating to the new MPLS, so already have entries via existing networks in OSPF via inter-area routes. Wh...
Hi all,I have had a few Cisco 7900 series phones returned to me recently with the same problem When the phone receives PoE the whole phone lights up the only the speaker light stays on and all else goes off. Factory reset not functional at this point...
Hi Ric,
Thanks again for coming back to me. I have discussed applying DHCP options, but i think time constraints and future planning may prevent this at this time. However i agree that managing controller access using DHCP options is a good option ...
Hi Ric,
First of all, thank you very much for your reply. That was extremely helpful and answered pretty much all of my questions.
The controllers are configure in mobility groups and the AP's aren't configured for primary/secondary/tertiary contr...
Hi Richard/Cofee, Richard, you were correct in your understanding. I was hoping to have this external, resilient route available to put in the routing table for a graceful cut over to the new MPLS routes when ready. But from what i can understand, I ...
Hi Cofee, Thanks again for your input. My question there would be, although i have a type 3 route learnt from the inter area route within OSPF, is there a way I can get OSPF to populate the external routes, even if inferior to the existing routes, as...
@cofee wrote:If you are learning the same prefix as a intra or inter area then external route would fail to install in global RIB.Thanks for this, I had a suspicion this would be case. However I haven't seen any supporting literature, do you have any...
