Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I work in an environment using Cisco Stealthwatch. We have a cybersecurity team that is doing an audit on our systems where they are scanning the network for vulnerabilities and other problems. I have to provide my management team with the outputte...
I have an Oracle DBA that is trying to connect to an App Server via an ESXi. When he connects to it to do his work, it will lose connection after about 10-30 minutes and he will lose his data.This is the physical connection:ESXi>>>>>>Cisco UCS>>>>>>...
I have an outside organization coming into my datacenter and they are going to monitor traffic on a number of VLAN's. The actual SPAN sessions have been setup correctly with the respective VLAN's, say 1, 2, 3, 4, and 5. However, I'm a little confuse...
Below is what it says about the flashing blue light on the front of my Cisco ACS: Flashing Blue = When the system ID button is pushed, the Unit Identification LED flashes blue if the system is in either standby mode or system power is on. 1. How can ...
1. I have tried 'acs stop' and 'acs start', it didn't work2. I have tried different browsers and devices.3. I have power-cycled the device within the CLI and physically power-cycled the ACS. Below is the output after is stop and start the services wi...
I work in a government environment, it's not that easy to just upgrade to ISE. This will happen in the future, however, this decision is above my pay grade.
Thanks for answering. I did read that about it already being enabled,but I could've swore I just saw the default 1500 on at least the interfaces. I didn't show int on the port channels or the int vlans.
Thanks for responding, so I can leave the configuration on the port configured like these 3 choices with no difference? interface TenGigabitEthernet2/0/38 switchport mode access switchport access vlan 2ORinterface TenGigabitEthernet2/0/38 switchport ...
I have tried start and restop the services, didn't work. I also tried ethernetting into it w/ the ACS ip and that didnt' work either, any other advice?
