Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had similar issue to the one described in CSCvz71596 and CSCwd54400 on the 9.18(2)5 ASA code. When creating new context, context subinterface assignment was not applied on standby unit and "Number of interfaces on Active and Standby are not consi...
Hi,Is it possible, and how, to attach multiple ACs to L3 interface on IOS-XR ASR900.Something like this configuration on ES20interface Gi1/1 service instance 10 ethernet encapsulation dot1q 10 rewrite ingress tag pop 1 symmetric bridge-domain 40in...
Hi,I have MPLS L3 VPN with EIGRP as PE-CE routing protocol. Also I have backdoor link, that needs to be preferred.So, I am using route map that sets bgp pre-bestpath cost community to some value.The question is, how can I distinguish between EIGRP in...
Hi everybody,Is there any way to limit number of C(ustomer)-VLANs on QinQ tunnel port?For example, only VLANS 10-20 are double tagged, all other traffic is dropped.Thanks,Branimir
You can configure policing on SVI on 3750. Check out chapter "Classifying, Policing, and Marking Traffic on SVIs by Using Hierarchical Policy Maps" on link belovhttp://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_55_se/con...
Kind of stupid question, have you created VLANs 10 and 20 on switch-1?Also can you ping both VLAN 10 and 20 IP switch 3 addresses from switch 2?Branimir
If every branch is different OSPF area you can use LSA filtering on HQ to filter which routes are sent to particular OSPF area.http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftabrt3f.htmlAlso you can use distributed lists at branch to...
