Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have kyocera printers connected with network cable linked with Cisco switch C9300-48UXM authenticated with ISE server communicates with WMS application serverall printers connected ok saif two printers, I do a continuous ping for the printers i...
Hello Team,
I have a C9800-L-F-K9 physical Wifi controller and "C9115AXE-E" type Wifi terminals. According to the official documentation of cisco activation option"Fast transition" allows customers a fast roaming and I need this option in my siteMy q...
As best practice, is it a good solution to do a reboot Wi-Fi controller and AP Cisco for sheduled reboot Is there a guide in the Cisco that talks about restarting Wi-Fi controller for refresh, for example, every month, or sometimes every quarter ther...
Hello,
I have Cisco Wlc 9800 , i add AP Cisco C9115AXE-E with success and interface 5 GHZ is enabled and operation status is greenBut in AP AIR-AP2802I-E-K9 i added in wlc but the interface radio for the both 2.4 GHZ and 5GHZ is redsee below these ...
I have Cisco wlc 9800 and AP Cisco 9115 i have issue with AP not joined Wlc issue is cisco wlc 9800 dtls_process_packet: DTLS Error: 1051how to solved this problem
hi @balaji.bandi
in an industrial environment, we use printers that communicate with application serversin my network side when I do ping test for the printers, it is operational and accessibleproblem for some kyocera printers not all printers my ma...
@Arshad Safrulla yes i try to solve issue about roaming in my site.
and my network existe i don't use "Enable Fast transition" , my wlan use 802.1x only
if i understand correctly in my scenario, if i enable fast transition you shoud be choose FT +...
Hi,
It is necessary to detail the design of your architecture and your configurationCreate step by step:1/ the port configured between Wifi Controller to Swtich must be (Trunk or trunk allowed vlan X,Y,Z)2/ the port configured between AP to switch ac...
