Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a VPN Lan-Lan from My Con to ChkPoint NG. The live log shows Phase 2 Established but there is no Ping response from My Site to the Remote site.To brief up, my Con is sitting in the DMZ.DMZ 1 is the outside of the Con.DMZ 2 is the inside of ...
Hi All,I have a Plan to implement 2 Network Management Solutions.1st Solution Qurey:Cisco WAN Manager (CWM) on a solaris machine running CWM 9.2I have ordered for a CWM-15.0.00JU=CWM Server Major Upgrade to R15.0.00 This is case of the following note...
Dear All,I keep receiving the below error message on the console whenever I login to the CAT.2006 Jul 03 05:21:42 %SNMP-5-SNMPAUTHFAIL:Authentication failed for message from 10.60.1.2002006 Jul 03 05:51:51 %SNMP-5-SNMPAUTHFAIL:Authentication failed f...
Dear All,Hope you can understand my scenario and give me suitable studylinks / Configs to achieve the same.I have a Core 4507 CAT doing 4 Vlans.In frnot of that I have a Pix with 6 Port FE ( DMZ )In front of that I have a Router with 4 Port FE for wh...
Hi All,Hope this mail finds you all in good health and high spirits.Comming to my query.I have in my network:Internet Router - Serial going to Leased Line.E1 connecting to the Pix 515 3FEE2 connecting to ADSL 1E3 Connecting to ADSL 2E4 Connecting to ...
Hi Gilbert,Yes it does show an IPSEC connection.The IPSEC TX is 20309 and keeps incresing when I initiate a ping.The IPSEC RX is 667 and this does not increase when I initiate a ping,rather increases when the remote site initiates a ping to my local ...
Bos,PBR will work on the Main RTR end I agree, but how will I get PBR to segregate the VLAN's on the core to specific ADSL Routers, cause I have a Proxy in between, all LAN PC's in all VLAN's will terminate into the Proxy, the proxy will terminate in...
Zulfi,Stopbits 2 may not quite work as my modem is configured for Stopbits 1. I would have tried Mak's option of changine the NM-8AM but its not right away available.The Router I have is a 2620 so only One slot so not much in luck there too.Thanx a t...
Hi Mak,Tried connecting to a simple POTS Phone instrument and it seems to be dialing perfectly fine without any hitch.I think the Chassis is grounded correctly.This is a very new Setup !Just configuring for All 8 LInes dialin. Am I missing anything i...
