About manojkumarnb

manojkumarnb · 10-08-2019

My network does not have an internet connection and need to configure the Core switch as an ntp server.My core switch is Catalyst 9k. How can I create catalyst 9k as ntp server. need all other switches to sync with this. regards,Manoj

manojkumarnb · 05-15-2007

Can we use XFP transcivers in Cisco WS-C3560G-48TS-S SFP port.

manojkumarnb · 05-08-2007

I have a question which may be very basic thing, but a network engineer should be very aware of. The question is .....While purchasing a router or a switch what all are the basic things or parameters or the attributes we should take care and how can ...

manojkumarnb · 03-24-2007

I have a catalyst 4507R switch. I would like to add two modules (24 port WS-X4424-GB-RJ45 and WS-X4418) in the existing 4507R switch. Do these modules are plug and play or I have to do some configurations in the supervisor? If any configuration neede...

manojkumarnb · 03-24-2007

How can we use the secondary address in a router interface ? How does it work ? What is the command to configure the secondary address in a router interface?

manojkumarnb · 03-24-2007

Thanks, this information is very knowledgable and very useful. Thanks once again.

manojkumarnb · 01-20-2007

from the config mode # access-list 1 permit 192.168.41.0 0.0.0.255 # access-list 1 permit 192.168.41.0 0.0.0.255 #ip nat inside source list 1 interface s0 overload ! in the serial interface # ip address public ip address # no shut # ip nat outside...

Member Since	‎02-17-2005 06:26 AM
Date Last Visited	‎12-11-2023 08:05 AM
Posts	12

User Statistics

User Activity

How to create a local ntp server.

Upgradation of Switch SFP ports

Network Infrastructure

Configration in 4500 catalyst switch

use of secondary address in router interface

Re: use of secondary address in router interface

Re: basic nat configuration