I'm trying to set up my access switches to all be managed on Vlan 1 (172.16.1.x/24). The first switch that I'm trying to set up is giving me issues. It seems that I am unable to have an IP address 172.16.1.10 for the managed IP address and have the...
I've set up a 3550 switch with a trunk connection to another 3550 switch to transfer all vlans accross. On the new switch i'm trying to configure a vlan interface (let's say vlan 2) with an IP address which is unique from the original switches vlan ...
I have two 6509s. Is there a way I can setup a virtual IP address for the Vlan Gateway? For example Vlan 2 could be 172.16.2.1 (as the virtual) 172.16.2.2 (primary) 172.16.2.3 (secondary). This way if one of my switches were to fail my workstation...
I currently have a 6509 Sup2 MFC CatOS in place and just bought a 6509 E with Sup720 IOS version. I want these two switches to communicate with each other and am wondering if I could set up approximately 10 ports as trunks between the two switches t...
They didn't specify which bug it's hitting specifically. what they did find is (when they debugged ip) that the switch was not sending anything through the ip default gateway.
I have just been informed by the Cisco TAC that they had set up a simulation of what I have on my network with the same cisco devices and they were having the same issues, however, when they had tested with a 2900 series switch it all worked fine. T...
My layer 3 interfaces are on the 6509s using HSRP.I do have vlan 1 and vlan 13 configured on the MLSwitches and all of the vlan interfaces are configured with an IP address. For example... 6509Ainterface vlan 13ip address 172.16.13.2standby 1 ip 172...
What you've just described is pretty much what I have. What should the native vlan on the trunk port be, or does it matter as long as they match up on both ends? I've also contacted the TAC and have been on the phone with them for over 3 hours and I...
