Anybody knows if I can insert a default static route based on the reachability of ISPs' DNS servers. No BGP. Just use simple tools as PING. The solution is not litmited to Cisco's products.Thanks.
Cisco recommends to orient the antenna horizontally as high as possible at or near the center of its coverage area. According to the E-Plane pattern, the best way is to place the antenna in the middle to best server the space below and above it. My p...
We have 2 distribution/core switches (6513) and about 40 access switches (4507 and 3550). What is the better way to connect the 2 core switches, L3 interface or trunk?Thanks,Bill
Looks like per-source CEF load sharing is not supported yet. Just want to know if Cisco has a plan to add per-source CEF load sharing. PBR (source based routing) load sharing can achieve similar goal in some case, but per-source CEF load sharing is N...
Somebody post a solution in this forum several years ago. Use a cheap IP phone and configure auto-answer to headset or speaker. Find the audio cable of headset or speaker. Connect the audio cable to your amplifier. That is it.Hope this helps.
With proper regeneration, you should be able to achieve your goal. I think without regeneration, you should be able to chain a few OADM1-xxxx together with MUX8A. Such as Cat6500|MUA8A -> 3560E|OADM1-1490 -> 3560E|OADM1-1510 -> 3560E|OADM1-1530. I am...
There is a way. Suppose all switch ports are in vlan 1. Put switch vlan 1 and Gi0/0 into same bridge group. Configure IRB. I tested the configuration in a 1841 router and it worked. Please be noted that 1841 only have fa0/0 and integrated switch has ...
