Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have ASA 5505 configured as EsayVpn client (System image: asa804-k8.bin).This ASA is connected to the LAN interface of the provider router.The providers reset each evening the WAN link of his router.When he do so the ASA is then not able to ...
Hello,I have a remote control sendingUDP packet ->src:172.17.1.173:1065 dst:255.255.255.255:30718 But the recepter (on wire network) do not receive anything.Both are on same subnet -> 172.17.1.160/28We do not use any ACLidea why?Many thanks for your ...
Hello,We are using a Cisco Lightweight Wireless network with around 100 AP and 3 controllers 4402 in L3 mode.We have a new Video system with Wireless 802.11b remote control. The thing is this system work only with mac address, so we need direct Layer...
Hello,Well...We have ports in access mode with 802.1x working perfectly (see config #1 bellow)We have ports in trunk mode for ericsson iphone (vlan 9) with a pc behind (vlan working also perfectly (see config #2 bellow)But but.... how can I have bo...
Hello,What is the advantage of enabling LACP or not?Our backbone is 6 3750 stacked together.The Access switch are 3750 alone.Each access switch have 2 giga interfaces to the backbone, this configured with etherchannel.We got the advices 1. To configu...
Hi thanks for the info.Well i understand, but its still stange.My wifi and fix network is configured properly.-> wifi remote control = 172.17.1.173/28-> terminal on fixe network = 172.17.1.165/28I can ping the terminal from the Wifi remote control bu...
Hello again,According to Ericsson support it is not possible so if we want to have 802.1x activated with Ericsson ipphone we will need to have one port for pc and one for ipphone..... If somebody can prove me the opposite i will be the first interest...
Hi,Thanks for the proposal, but we can't configure dot1x with a trunk (so far I know and tried).I'm in contact with Ericsson, according to them, the switchport voice 9 do effectivaly works, So the following configuration is okinterface FastEthernet1/...
Hi,Thanks for your reply, But my question is what is better when using only cisco, when having 1000BaseLx,LACP or nothing->Betterchannel-group 1 mode passive/active orchannel-group 1 mode on ThanksCheers.Gael
