My controller seems to stop udp broadcast

[gael.clavadetscher]

Hello,

I have a remote control sending

UDP packet ->

src:172.17.1.173:1065 dst:255.255.255.255:30718

But the recepter (on wire network) do not receive anything.

Both are on same subnet -> 172.17.1.160/28

We do not use any ACL

idea why?

Many thanks for your precious help.

Cheers

Gael

[ankbhasi]

Hi Gael,

Have you enabled broadcast on controller? Can you try "config network broadcast enable" and see if that resolves the issue.

Regards,

Ankur

*Pls rate all helpfull post

[descalante2007]

Hi Gael,

Did you get solution to your problem? I have a similar case where UDP port 11050 is being blocked. The customer application uses it for license management.

regards