Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just purchased a C9105AXI to add to a small wireless domain, managed on a single C9130AXI. It is not joining the domain as the version is too old and it is not automatically getting the software from the controller. The 2 devices are in the same V...
I have a C9130axi running 17.3.3 in EWC mode.I would like to add an additional AP (3802i). I have added the new AP to a Cisco Catalyst 3850: interface GigabitEthernet1/0/25description "Cisco 9130axi EWC AP"switchport trunk native vlan 424switchport t...
I have a C9130axi running 17.3.3 in EWC mode.I would like to add an additional AP (3802i). I have added the new AP to a Cisco Catalyst 3850: interface GigabitEthernet1/0/25description "Cisco 9130axi EWC AP"switchport trunk native vlan 424switchport t...
I have searched the normal locations that Cisco posts MIB support and cannot find anything for this wireless controller: C9130AXI Cisco Catalyst 9130AX Series Access Points Data Sheet - Cisco Any suggestions? Chris Callison
I am using my AP in EWC mode. I am using Windows 2019 NPS as the AAA authority. I have set up admin (web & ssh) access and have set up 802.1x for one of my WLANs and it is working as expected. I would like to have a few WLANs that are restricted b...
I've upgraded the C9130axi to 17.4.1, but still no luck with the other AP. I am seeing this error: *Aug 14 02:48:12.128: %CAPWAPAC_SMGR_TRACE_MESSAGE-5-AP_JOIN_DISJOIN: Chassis 1 R0/0: wncd: AP Event: AP Name: AP58AC.78F8.B7BE Mac: 192.168.42.134[52...
I turned off the lsc function with no changeIs it possibly a minimum version problem? i know there is a table somewhere but i can't recall where. My 3802i is running the following version cisco AIR-AP3802I-B-K9 ARMv7 Processor rev 1 (v7l) with 1030...
I've got them in the same VLAN so the EWC should be accessible without the DHCP option. I have added it in nonetheless, but no change. same set of recurring errors on the AP
For my environment, it's really only useful for a general use tablet and the lack of encryption makes it seem pointless. I was also not able to turn off SSID broadcasting, so I don't think I will use it. I seem to remember applying a mac address acl...
If I use the sub-interface on the gi0/1/0 interface and set the vlan on the switchports, do I need the bridge, or will that just work because of the tagging?
