About mSumo

mSumo · 05-28-2023

Hi all, I am quite new to meraki solutions... and looking to deploy few Meraki AP (probably MR36 or 28 models). The client has some specific requirements below: 3-floor buildingeach floor will have their own SSID (such as 1st floor - Sales; 2nd floor...

mSumo · 09-21-2022

Hi,I'm trying to find out how to route a call to a specific extension (XX) the way that if it rings 5 times, it does not go to its VM but instead it rings another group of extensions. I just could not find about how to change it from VM to a group......

mSumo · 08-11-2022

I've came across an old CISC U560 PBX and was asked to configure one thing here that I'm not sure whether it is even possible.All external incoming calls are forwarded to a specific extension (XX) and if not answered, they are forwarded to a "blast g...

mSumo · 03-30-2021

Hello all, I've just got a very basic question about SIP connecting to UC560 as I'm not very experienced with cisco UC We have been using it for a while already with BRI ISDN lines - all works fine. However, the provider is going to get rid of ISDN s...

mSumo · 02-21-2020

Hello all, I've been ask by friend of mine to help with troubleshooting of the issue he is experiencing with Nexus. The problem is that they are losing all devices on "Eth101/1/" , FEX101. This has been occurring for some time but they only noticed n...

mSumo · 05-28-2023

there is no tacas server.... It is a small customer with very basic set up... Could you please advise whether at least the WIFI ambassador is used for a selected user to change password for SSIDs etc? Or will have to be a proper admin role.

mSumo · 09-26-2022

I've found that I can configure it directly under the extension - where I've found "Call fwd busy; Call fwd No Answer"..... I've used Blast Group extension and it works fine. Thanks

mSumo · 02-24-2020

thanks for your posts Mark.... very useful for me... LACPIm not 100% sure here.... the port is configured like the below... The "feature lacp" is configured globaly, but from "show port-chan sum", I can see the PROTOCOL for 101 is NONE.... However, I...

mSumo · 02-24-2020

I've just got some additional checks I asked for - see below. Also, got a log when Eth1/1 is UP, Po101 is UP, but FEX 101 is DOWN (attached)- could this be a state when we consider cable/sfp issue? What I asked for: check sh int Eth1/1 few times over...

mSumo · 02-24-2020

thanks for confirmation.... About "3 - power issue" - I would say that if there is a power issue on the 2k side, that would cause that FEX going down also on CORE-B?

Member Since	‎07-10-2018 12:10 PM
Date Last Visited	‎05-31-2023 12:02 AM
Posts	23

User Statistics

User Activity

Meraki AP-Give selected users access to changing passwords for SSIDs

Route a call from a user to group instead of VM (UC560)

CISCO UC560 - different rules for external and internal incoming calls

UC560 SIP Connection

FEX bouncing

Re: Meraki AP-Give selected users access to changing passwords for SSI

Re: Route a call from a user to group instead of VM (UC560)

Re: FEX bouncing

Re: FEX bouncing

Re: FEX bouncing