Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everybody,I am trying to deploy QoS for EoMPLS ERS service and would like to offer four Class of Service on a single ERS VC. I am trying following config on Cisco 7606 Router with SUP720 3BXL and PFC3BXL.My customer facing port is Gig Ethernet ...
I am trying to do dyanamic nat on my router. My requirement is to provide private ip users internet access. I am trying to use pool of public ip address to nat the private ip users.The configuration is as below :interface GigabitEthernet0/0 descripti...
Surely MPLS would help You can have L2 and L3 connectivity both within the same physical connectivity if required . But it boils down to how u would wish to handle routing and traffic. Pls rate the post if it helps ..raj
Hi,If i dont use per vlan queueing , and dedicate a port for my requirment should i be able to do so ? i mean EoMPLS in Port mode. I dont mind sparing a port than looping it to OSM blade for sake of avoiding the complexity.Also if i go by looping on ...
Hi,config shown above seems to be okay, as far as your l3 vpn is concerned.What i understand is you are going to connect your customer on 3750 where you will be configuring the port facing customer as access vlan port for vlan 300, the trunk port con...
Well.. its about product features .. you gotta compare products with your requirments at various layer of your network and to come out with justification of your requirments . Any ways below is snippet for you to have some justification between two p...
