Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, NetPros!I'm trying to design a fail-safe enterprise edge solution. Let me explain... We are using 2 7200 routers and 2 Ethernet connections onto 2 different ISPs.First requirement is if we are completely losing one of the routers, enterprise netw...
Hi!I have faced with such trouble:Imagine what our clients uses 2 type of equipment:1) Laptop/Desktop with Cisco IPSEC VPN Client installed2) PDA, which is running Win2003M, running native Windows L2TP over IPSEC.I can successfully configure only one...
Hi, guys!"....When used for edge switch applications in a large enterprise SAN, large numbers of lower performance devices, maybe concentrated, four-to-one onto MDS 9000 family ports. Unlike traditional switches, 9100 switches can provide switch fan-...
Hi, guys!Can someone explain me for which purpose i need ingress queuing by subj. command.AFAIK, queuing is only make sense in "egress side": if output interface rate much slower then current ingress data streams. I just can't understand how router w...
Hi, All.Is it possible to use multilayer switch (like 3550) as router-on-stick?[layer2-only sw w. some vlans]--- dot1Q ---[3550 with ip routing enabled]May it work?Thanx in advance.
Try to get only your peers and their clients originated routes :AS-Path-Filter ^_[0-9]*$AS-Path-Filter ^_[0-9]*$then examine if one or two of your ISPs send a default route to you, and if they do then accept it too. If they do not then you should fig...
Hi,Here some hints from configuration guide on ME3400:These are the configuration guidelines and restrictions for CFM:?You cannot configure CFM on an EoMPLS port.?CFM is not supported on private VLAN ports or IEEE 802.1Q tunnel ports. The configurati...
Perhaps the state of things is not so bad as you describe. I do think that you'd be able to implement lots of policies even with 32K FIB. You know full-view table gives you the best flexibility in terms of defining routing policies, however you mig...
A colleague has founded an interesting link:http://cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_guide09186a0080699540.htmlSo the answer to your question isn't so obvious as used to think.
